pmg4111a0600p_01
5 / 24
4.
MOUNTING
M
OUNTING BRACKET
The unit can be mounted with the help of the
supplied mounting bracket to the suitable cut-
out hole. Be careful with the sealing, which
provides proper sealing from the front panel.
Suitable distances between multiple units
should be taken into consideration.
The cut-out dimensions in case of single, or
multiple units should be the following, and
width of the mounting-plate is 3 - 9 mm.
Using the optional
PAM-500-0
front panel adapter the 48x48mm sized unit can be mounted to an existing
96x48mm cut-out hole. In case of using the front panel adapter, the width of the mounting-plate is
3–5 mm.
APPROPRIATE CONDITIONS OF OPERATION
The device is designed for indoor usage only and it should be protected from intense physical damage
and direct sunlight. The device cannot be applied in the following places:
environments which are exposed to strong vibration or other heavy physical impacts
flammable and dusty environments
environments above 85% relative humidity and where sudden temperature changes can happen
strongly acidic or alkaline environments
environments which are exposed to direct sunlight
environments which are exposed to strong magnetic fields or strong electrical noise
5.
WIRING
5.1
I
NPUT SELECTION
To select the input mode it is necessary to detach the housing.
Before performing the operation always make sure that the
device is powered OFF!
Removing the housing should be carried out in two steps
shown in the drawing. First press gently the two clips on the
back side of the device, and then pull backward the inside part
of the device. Select the desired input mode with the help of
the S/W1 and the S/W2 pins and the jumpers on the circuit
board. After setting the jumpers, replace the housing to the
device.
A.)
RTD
INPUT AND
T
HERMOCOUPLE INPUT
B.)
V
OLTAGE INPUT
(1-5
V
DC;
0-10
V
DC)
C.)
C
URRENT INPUT
(4-20
mA)
S/W1 S/W2
S/W1 S/W2
S/W1 S/W2