NIVELCO UNICONT PMG-400, User And Programming Manual, Page: 11 / 24

pmg4111a0600p_01

11 / 24
7.2 B
ASIC OPERATION
Normal
(measurement)
mode
Setting the
control
parameters
Enter the
Set Value
(SV)
Mode
Settings
3 s
3 s
3 s
Note:
The controller returns automatically from configuration mode, to normal (measurement) mode if there is no key
activity for 60 seconds.
7.3 E
RROR MESSAGES
If any error occurs during the operation of the controller the display shows the following error messages:

”  ” flashes on the display if input sensor is not connected or its wire is broken.
 ”  ” flashes on the display if the measured value is lower than the low limit value in the input
range of the sensor (it is likely because the range selection is wrong).

”  ” flashes on the display if the measured value is higher than the high limit value in the input
range of the sensor (it is likely because the input selection is wrong).
 ”  ” appears on the display if the device is defective and does not operate.
7.4 S
ET
V
ALUE
(SV)
1. 2.

In normal (measurement) mode, press the  button.
The first digit of the set value will be flashing.
Once the desired SV is entered with the arrow buttons
(

,

,
 ) press the button to accept the new
value. Then the device will return to normal
(measurement) mode.