jbdp612a0600p_02
♦
6 / 12
3.
PROGRAMMING
3.1
O
PERATING AND DISPLAY MODULE
Status LED
Set Point 2
Status LED
Set Point 1
Display
" " button
" " button
SP 2
SP 1
The device has a green LED for displaying the active contact of set point 1 and a yellow LED
for displaying the active contact of set point 2. The LEDs will light up when the respective set
point has been reached and the contact is active. The LED for set point 1 also shows that
there is a communication between pressure switch and programming device.
The display of the measured value as well as the configuration of the individual parameters
occurs through a menu via a 4-digit seven-segment display. The individual functions can be
set with the help of two miniature push buttons located in the front:
–
"▲" button: with this button, you move forward in the menu system or increase
the displayed value
–
"▼" button: with this button, you move back in the menu system or decrease
the displayed value
–
both buttons simultaneously: if both buttons are pushed simultaneously, the device
changes between display and configuration mode; you can also confirm the menu
items and set values with them.
You can increase the counting speed by keeping the respective button ("▲" or "▼"), if the
button is pressed for more than 5 seconds.
3.2
C
ONFIGURATION
All settings are permanently stored in an EEPROM and therefore available again even after disconnecting from the supply voltage. The menu system and the
menu items have been designed as simply as possible. Below, each individual menu item is described in detail allowing a straightforward and quick
configuration of your device.