24 / 50
sbd31jen21p05
5.3.4.
Full Parameter Access
Access to all features of the EchoTREK
The description of all parameters can be found in chapter 5.4.
K
EYS
O
PERATION
+
(press for 3 s!)
Enter into or exit from the Full Parameter Access programming mode
The display will show PROG and the following screen:
yy is the Parameter Address (
Pyy
=
P01
,
P02
…
P99
)
xxxx is the Parameter Value (dcba - codes or numbers)
Measuring continues during programming in using the old settings. The new settings will be valid after returning to measurement from programming
mode.
K
EYS
W
HILE
P
ARAMETER
A
DDRESS IS BLINKING
W
HILE
P
ARAMETER
V
ALUE IS BLINKING
Go to the Parameter Value
Save the modified settings and return to the Parameter Address
+
(min. 3 s)
Cancel all modifications of the current programming phase
CANCEL will be displayed for warning
Discard the modified settings and return to the Parameter Address
without saving the modifications
+
Reset the device to factory defaults. It will reset all parameters,
“LOAD” will appear on the display:
- press
to confirm
- press any other key to cancel
Display the default value of the current parameter.
(it can be saved by pressing
)
Move the cursor to the left
/
Modify the cursor (increase, decrease) or scroll up/down
Summary of key
combinations
Summary of Contents for EchoTREK S-300
Page 1: ...sbd31jen21p05 1 50 ...
Page 3: ...sbd31jen21p05 3 50 ...
Page 5: ...sbd31jen21p05 5 50 ...
