6
laser level again (or turn off the TILT by holding longer the button 5)
6) directional scan button - narrowing of the laser line in the required range (where the work is
carried out)
- available display of beam angles: 0-10 ° -45 ° -90 ° -180 °. Each press will switch the display
of the beam angle.
7) MINUS / right rotation
- Use the key to: subtract the value of inclination (minus) / heads turn to the right (when the
head is not spinning or level is switched into scan mode)
8) PLUS / counter-clockwise rotation
- Use the key to: add the value of inclination (plus) / turn heads left
WORKING WITH LASER LEVEL
Turning on the power
On the front panel press button 1. The instrument will level by itself and the power LED lights
up. Press the button again to turn off the power.
Once leveled up, the laser LED stops blinking and the laser head rotates at a speed of 600 rpm.
If instrument will be is set inclined more than ± 5 °, it won't level by itself.
Rotating laser head mode
button 2 allows you to adjust the speed of laser head rotation. Switching the speed is carried out
by pressing again this button
Scan mode
Adjust the rotating speed of the head. Press button 6 which will cause the device goes into scan
mode, the laser will begin to "draw" a line at set distance. Each time when you press this button
you will cause increase the range of "drawn" line. Depending on your needs, switch the direction
of rotation of the head (clockwise or counter-clockwise).
The inclination of laser plane
NL510/510G allows you to incline the laser plane in one or two directions
Press 4 button which will go into a mode of enter the inclinations
Press 3 to enable selection of the axis along which surface will be tilted (X or Y).
To set the inclination in the X-axis, press the buttons 7, respectively (positive values) or 8
(negative values) - every time pressing the laser beam will tilt to the surface - in the X or Y
plane, on the top cover of the laser are marked directions of inclinations. Positive values will
incline laser plane according to the arrow on the top cover, negative - in the opposite direction)
After entering the inclination value for the X-axis, Y-axis, press 3 again after approx. 3 seconds,
the plane begins to be tilted to entered values.
Press the 4 button to exit set inclination mode, the plane will be automatically levelled.
Summary of Contents for NL510
Page 16: ...16 ...
