Operation and Maintenance Manual
Second Edition
14
Maxiton GTJZ
If the drive speed with the platform raised exceeds
0.8km/h, immediately tag and remove the machine from
service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
34 Fully lower the platform.
35 Place a 2x4 or similar piece of wood under both
wheels on one side and drive the machine up onto
them.
36 Raise the platform approximately 3.5 m from the
ground.
37 Lower the platform and remove both pieces of
wood.
Test the Pothole Guards
Note: The pothole guards should automatically deploy
when the platform is raised. The pothole guards activate
two limit switches which control the machine drive
speed. If the pothole guards do not deploy and the
platform is raised above 3.5 m, an alarm sounds and
the machine will not drive.
38Raise the platform.
Result: When the platform is raised 3.5 m from the
ground, the pothole guards should deploy.
39 Press on the pothole guards on one side, and then
the other.
Result: The pothole guards should not move.
40 Lower the platform.
Result: The pothole guards should return to the stowed
position.
41 Place a 2x4 or similar piece of wood under a
pothole guard. Raise the platform.
Result: Before the platform is raised 3.5 m from the
ground, an alarm should sound and the drive function
should not work.
42 Lower the platform and remove the 2x4.
Workplace Place Inspection
You learn and practice the principles of safe machine
operation contained in this operator's manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
Know and understand the workplace inspection
before going on to the next section.
5 Only use the machine as it was intended.
Fundamentals
The workplace inspection helps the operator determine
if the workplace is suitable for safe machine operation.
It should be performed by the operator prior to moving
the machine to the workplace.
It is the operator's responsibility to read and remember
the workplace hazards, then watch for and avoid
them while moving, setting up and operating the
machine.
Workplace Inspection
Be aware of and avoid the following hazardous
situations:
drop-offs or hole
bumps, floor obstructions or debris
overhead obstructions and high
voltage
conductors hazardous
location
inadequate surface support to withstand all load
forces imposed by the machine wind and
weather condition the presence of
unauthorized personnel other possible
unsafe condition
Operating Instructions
Do Not Operate Unless:
Do Not Operate Unless: