Nitto Seiko KX Series, Instruction Manual

Page: 3 / 30

KX driver tool unit
1
Introduction
Thank you for purchasing the “KX driver”. The “KX driver”, which combines a tool unit and a controller
unit (SD550 series) into one, is a high-performance driver using an AC servo motor for fastening screws
etc.
To use the “KX driver” controllers correctly for many years, read this manual carefully.
General precautions

All rights reserved. No part of or whole of this may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means without the prior written permission of Nitto Seiko Co., Ltd.

By provision of operating manual recorded on CD-ROM, you shall be deemed to have agreed to the
Terms and Conditions written in “readme.txt” on it.

Contents of this manual are subject to update without notice according to specification change of the
products.

Unique nouns like the product name indicated in this brochure are registered or not registered trademark
of each company.

In the figures of this manual, the products may be shown with the covers and safety shielding materials
removed for the ease of explanation on detailed parts. When you operate a product, be sure to replace
specified covers and shielding materials and follow the Instruction manual.

Since the figures in the manual show typical examples, the products you have received may differ from
the figures.

The Instruction manual may be changed as appropriate due to product modification and improvement of
ease of use of this manual.

If the Instruction manual is damaged or lost and you require a new one, contact our agent or nearest
sales office.

The products modified by users are out of warrantee coverage. We are not responsible for such products.
Precautions for use

A final fastening torque value may vary depending on the output shaft rotation speed of a driver, and the
inertia of the joint attached to the output shaft and so on. Set the motor current value and rotation speed
properly according to the Instruction manual.

Parameters (motor characteristic values) vary depending on tool unit model. Be sure to specify proper
parameter values in accordance with the Instruction manual when a tool unit and the controller are
connected. If an incorrect value is specified, the tool unit or the controller may be damaged.
Tool units covered by this Instruction manual

KX050T2-01M*-20

KX050T2-01H*-20

KX100T2-01M*-20

KX100T2-01H*-20

KX150T2-01M*-20

KX150T2-01H*-20

KX150T2-01S*-20

KX100T2-03M*-20

KX100T2-03H*-20

KX100T2-03S*-20

KX150T2-03M*-20

KX150T2-03H*-20

KX150T2-03S*-20

KX150T2-07M*-20

KX150T2-07H*-20

KX150T2-07S*-20

KX400T2-07S*-20

KX400T2-14S*-20
「
*
」
mark into the version number