12
0$&+,1(23(5$7,21
WARNING
●
$OZD\V:HDU6DIHW\*ODVVHV
●
$OZD\V:HDU+HDULQJ3URWHFWLRQ
●
:HDUUHVSLUDWRU\SURWHFWLYHHTXLSPHQW
CAUTION
●
' R Q R W X V H K D U G P D W H U L D O V X F K D V D
VFUHZGULYHUWRRSHUDWHWKH0RWRU6ZLWFK7KLV
PD\ GDPDJH WKH SDQHO DQG VZLWFK ZKLFK
ZRXOGOHDGWRPDFKLQHIDLOXUH
6WDUWDQG6WRS
●
7KH'ULOO0RWRUZLOOQRWURWDWHXQOHVVD0DJQHW
LVWXUQHGRQLQRSHUDWLQJWKH0RWRU6ZLWFK
6WDUW
●
0DJQHW21
(Fig.15)
Turning the Magnet Switch ON illuminates the
switch lamp and energizes magnetic power.
●
'ULOO0RWRU21
(Fig.16)
Turning the Motor Switch ON starts the Drill Motor.
MAGNET
MOTOR
push
push
Fig. 15
Fig. 16
6WRS
●
'ULOO0RWRU2))
(Fig.17)
Turning the Motor Switch OFF stops the Drill
Motor.
●
0DJQHW2))
(Fig.18)
Turning the Magnet Switch OFF turns off the
switch lamp and Magnet power.
MAGNET
MOTOR
push
push
Fig. 17
Fig. 18
'ULOOLQJ3URFHGXUH
3XQFK0DUNLQJ
Put a rather large punch mark in the workpiece by
driving a punch down with a hammer. The punch
mark will be used as a guide for drilling operation
that follows, so it must be made in accurate
position. (Fig.19)
Punch Mark
Fig. 19
.HHS WKH 0DJQHW DQG :RUNSLHFH &RQWDFWLQJ
6XUIDFHV&OHDQ
WARNING
●
$OZD\VNHHSVXUIDFHVFOHDQ
Always keep the Magnet surface clean. Always
keep the work piece surface clean. If there are any
IRUHLJQREMHFWVEHWZHHQWKH0DJQHWDQGWKHZRUN
piece surfaces, this will reduce magnetic power.
This could cause the machine to move during
operation. This can result in an accident. Keep
all surfaces clean of rust, chips or other foreign
material.
$OLJQLQJZLWK3XQFK0DUN
Turn the Rod Handle counterclockwise to slightly
lower the cutter and align the tip of Pilot Pin to the
punch mark. (Fig.20)
Punch Mark
Fig. 20