niteo POJM220033, Instruction Manual

Page: 25 / 36

25
h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles
and grasping surfaces do not allow for safe handling and control of the tool in unexpected
situations.
5 . Service
a) The power tool must be repaired by qualified personnel using original replacement parts.
Doing so will guarantee safe operation of the device.
6 . Safety warnings common for sanding operations:
a) This power tool is intended to function as a sander for sanding with sandpaper. Read all
safety warnings, instructions, illustrations and specifications provided with this power tool.
Failure to follow all instructions listed below may result in electric shock, fire and/or serious
injury.
b) Operations such as ordinary sanding, wire brushing, polishing, hole cutting or cutting-off
are not to be performed with this power tool. Operations for which the power tool was not
designed may create a hazard and cause personal injury.
c) Do not convert this power tool to operate in a way which is not specifically designed
and specified by the tool manufacturer.
Such a conversion may result in a loss of control
and cause serious personal injury.
d) Do not use accessories which are not specifically designed and specified by the tool
manufacturer.
Just because the accessory can be attached to your power tool, it does not
assure safe operation.
e) The rated speed of the accessory must be at least equal to the maximum speed marked on
the power tool. Accessories running faster than their rated speed can break and fly apart.
f) The outside diameter and the thickness of your accessory must be within the capacity rating
of your power tool. Incorrectly sized accessories cannot be adequately guarded or controlled.
g) The dimensions of the accessory mounting must fit the dimensions of the mounting hardware
of the power tool. Accessories that do not match the mounting hardware of the power tool will
run out of balance, vibrate excessively and may cause loss of control.
h) Do not use a damaged accessory. Before each use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or accessory is dropped, inspect for damage or install
an undamaged accessory. After inspecting and installing an accessory, position yourself
and bystanders away from the plane of the rotating accessory and run the power tool at
maximum no-load speed for one minute.
Damaged accessories will normally break apart
during this test time.
i) Wear personal protective equipment. Depending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or workpiece fragments.
The eye
protection must be capable of stopping flying debris generated by various applications. The
dust mask or respirator must be capable of filtrating particles generated by the particular
application. Prolonged exposure to high intensity noise may cause hearing loss.
j) Keep bystanders a safe distance away from work area. Anyone entering the work area must
wear personal protective equipment.
Fragments of workpiece or of a broken accessory may
fly away and cause injury beyond immediate area of operation.
k) Do not run the power tool while carrying it at your side. Accidental contact with the spinning
accessory could snag your clothing, pulling the accessory into your body.
l) Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the housing
and excessive accumulation of powdered metal may cause electrical hazards.