Copyright © 2022 - www.niteforce.mobi
>
Update cycles can be set between 0 and 999. In APP, standard update times set to 999 (999 = infinity)
>
If the update interval is set for example every 10 seconds, in practice the location information is visualized every 12
seconds because the GPRS connection linked to the APP of your phone via the server, can cause an extra delay in
visualization for a couple of seconds
>
Enter the password for the commands in the Live Map software APP:
a123456
>
The collar sends a low battery alert via SMS to the Master user when the battery charge (less than 20%) decreases.
For a 1% charge, the device will send a notification and turn it off, then charge it for at least 1 hour
>
Li-on battery life always varies depending on prevailing air temperature and refresh rate
>
Always charge the battery after and prior outdoor use (use 5.0V / 1000mA mobile phone chargers)
>
Collar Operating temperatures: -10°C to + 40°C
>
Weather protection rating when screws tightly closed: IP67 (protected from dust and immersion for 30min at a
maximum water depth of 15cm)
RESETING AND RESTORING ALL COLLAR DATA BACK TO FACTORY DEFAULT SETTINGS
The collar can be reset from all data and reset to the factory settings as it was new on arrival, for example incase if you
want to re-sell or transfer it to a new owner or just reset it. The collar is reset from all settings if the following text
message is sent to it from the Master 1 user number:
FACID,123456,DEFAULT;
You can now start reprogramming the device from the beginning according to the instructions.
TURN COLLAR ON / OFF
To turn ON/OFF the device you use the small magnet for 3 seconds close to the LED (SIM card inserted to the device)
as shown below picture:
