9
Wireless Flash Shooting
NAS
Pairing before use.
!
Step 1: Set all NAS flashes and NAS receivers to pairing mode one by one.
Nissin Air R Receiver
1. Make sure the Nissin Air R is off.
2. Rotate the "Ch" channel dial to "Auto" auto channel mode.
3. Hold the power button for 3 seconds
4. “Beep” sound persists until the Pairing signal from commander is received.
When the "beep" sound stops, the pairing is complete.
5. After Pairing process is completed, turn off the Nissin Air R. Install a compatible
flash onto the Air R and make sure that both the Air R and the Flash are turned off.
Then turn on the Nissin Air R and the paired flash.
6. Set the flashgun on the Nissin Air R to TTL mode (or set the Nissin flash
to “A” fully automatic mode), Auto zoom mode and
+/- 0EV exposure compensation setting(*).
7. According to the GN value of the flash to set the GN mode of Nissin Air R
to high / low output mode (*)
(*) Please refer to the instruction manual for the model
CAUTIONS
If there are many NAS flashes and NAS receivers as slave units, you can do the
pairing one by one or several slave units at the same time by using NAS commander.