4
UK
Telephone Helpline: 0845 146 2887
Nisbets Essentials prides itself on quality and service,
ensuring that at the time of packaging the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your Nisbets Essentials dealer
immediately.
Installation
Note: If the unit has not been stored
or moved in an upright position, let
it stand upright for approximately 12
hours before operation. If in doubt
allow to stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. When positioning the ice maker, maintain a
distance of 20cm between the unit and walls or
other objects for ventilation.
NEVER LOCATE
NEXT TO OR NEAR A HEAT SOURCE.
WARNING: When positioning the
appliance, ensure the supply cord is
not trapped or damaged.
WARNING: Do not locate multiple
portable socket-outlets or portable
power supplies at the rear of the
appliance.
Operation
Control Panel
SMALL ice cube
indicator
ADD WATER indicator
ICE FULL indicator
POWER button
SELECT button
CLEAN button
LARGE ice tube indicator
Making Ice
Note: Before using for the first time,
clean the water tank, ice basket
and ice basket shelf. Use the first
3 ice making cycle to flush out the
system. Discard the water and ice
created from the first 3 cycles.
Each time the appliance is refilled, the first ice making
cycle is used to reduce the water temperature.
This results in uneven ice cube production which is
perfectly normal. You may wish to discard ice created
in the first two production cycles.
1. Lift the access lid and fill the water tank up the
level of the ice basket shelf.
2. Connect the appliance to the power and press
the “
POWER
” button.
3. Press the “
SELECT
” button repeatedly to scroll
through the ice cube sizes. Stop when the
required size is illuminated.
Note: The ice making cycle will
vary depending on the size of cube
selected. Larger cubes will take
longer to produce.
4. The appliance will run a start-up routine and then
begin ice production.
Note: If the water level is too low,
the ADD WATER indicator lights up
and the appliance stops working. Fill
the water tank and the appliance will
restart automatically.
5. When the cubes reach the ice sensor the
appliance will stop production. Production
resumes once ice has been removed.
Cleaning, Care &
Maintenance
•
Always switch off and disconnect the power
supply before cleaning.
• Warm, soapy water is recommended for cleaning.
Cleaning agents may leave harmful residues.
DO NOT wash the base unit, instead wipe the
exterior with a damp cloth.
DC439_UK_A5_v1_20191223.indb 4
2019/12/23 14:54