Need Help?
877.716.8550
starlight.org/gaming/support
28
4.5
Install the Nintendo Switch Console
1.
Make sure the Gaming station main power cord is disconnected from power.
2.
Use the key provided with the Gaming station to unlock both locks on the underside of
the main cabinet.
3.
The entire top of the cabinet can be
removed from the Gaming station. To
remove, lift the front of the cabinet up to
slightly tilt the cabinet cover and to get a
solid two-hand grip on the cabinet cover.
Then lift the cabinet cover straight up until
the two tabs on the back of the cover exit
the bottom cabinet.
4.
Remove the console cover assembly – if it is
secured with nuts, use a 7/16” socket driver
to remove the nuts.
5.
Set the Nintendo Switch into the dock with the screen of the console facing you.
6.
Place the console bracket onto the back side
of the dock, with the hooks on the bracket
(red arrows) grasping the back of the dock.
7.
Then slide the dock and bracket against the
PEM studs. Secure the bracket in place using
a 7/16” socket driver and the nuts that were
stored in the cabinet.
8.
Install the console cover assembly back over
the console and dock. Make sure to route
any cables so they do not get pinched between the cover assembly and the cabinet.
9.
Use a 7/16” socket driver to reinstall the two nuts that hold the console cover assembly
in place.
10.
Install the cabinet cover by inserting the back tabs of the cover into the slots in the back
side of the bottom cabinet, then lower into place.
11.
Use the key provided with the Gaming station to lock both locks on the underside of the
main cabinet.
12.
The controllers may need to be synced with the console.
•
See section 4.2 Sync the Pro Controller
•
See section 4.3, Sync the Joy-Con controllers
