IS-TWL-DEBUGGER Setup
2008-2009 Nintendo
13
TWL-06-0024-001-E
CONFIDENTIAL
Released: March 17, 2009
4.2 Turning the Power On and Off
Always use the following procedure to turn the power on.
1. Turn on the power switch on the back of the main unit.
2. The POWER and SYSTEM lights on the front of the main unit illuminate as follows.
a.
The POWER light briefly illuminates red.
b.
The POWER and SYSTEM lights illuminate green.
c.
If the SYSTEM light goes out after a few seconds, the device can be used.
3. The device can be used when the controller POWER light and the LCD backlight are illuminated.
Note:
The device can be used approximately eight seconds after turning the power on.
To turn the power off for the IS-TWL-DEBUGGER device, use the power switch on the back of the main
unit.
4.3 Installing the Software
To install IS-TWL-DEBUGGER software onto a computer, log on to Windows as a user with an
Administrator account on the computer.
1. Exit all currently running programs.
2. Download the IS-TWL-DEBUGGER software from the TWL Downloads page at
http://www.warioworld.com
.
3. Using Explorer, browse to the location to which the IS-TWL-DEBUGGER software was downloaded.
4. Open the IS-TWL-DEBUGGER folder and start installation by double-clicking
IS-TWL-DEBUGGER_XXX.EXE
(
XXX
represents the version).
5. Follow the displayed instructions.
6. If the installation program completes normally, the installation is complete.
If you are using IS-TWL-DEBUGGER with the CAPTURE OPTION, continue to install
IS-TWL-CAPTURE software.
7. Download the IS-TWL-CAPTURE software from the TWL Downloads page at
http://www.warioworld.com
.
8. Using Explorer, browse to the location to which the IS-TWL-CAPTURE software was downloaded.
