16
17
1-877-646-5288
ninjakitchen.com
SIGNATURE BREW
SPECIALTY BREW
1
After filling the water reservoir, insert
either the COFFEE or TEA filter holder
into the brew basket. Add the ground
coffee, loose leaf tea, or tea bags to
the filter.
2
Close the brew basket, ensuring it is
securely in place. The control panel will
display either COFFEE settings based on
the filter holder that has been inserted.
3
Place the empty vessel you would like to
brew into under the brew basket.
4
Turn the START/SELECT dial to choose
SPECIALTY
5
If brewing tea, press the Tea button
to toggle to the tea menu, and use the
dial to choose your tea type. To change
your brew style while in the tea menu,
press the Tea button again.
6
Press the START/SELECT dial to start the
brew. A progress bar on the control panel
will show the status of the brewing cycle.
To cancel the brew at any time, press the
dial again or press the Power button.
7
The unit will beep and the clock will
display “End” when the brew is complete.
SETTING THE DELAY BREW
1
Plug the unit in and turn the unit on by
pressing the Power button.
2
After filling the water reservoir and
adding ground coffee or tea to the
correct filter holder, be sure the
reservoir, brew basket, and filter are
securely in place. Place the appropriate-
size vessel under brew basket.
NOTE:
The brewing cycle will begin,
then pause for a short period before
resuming. This process is used to evenly
saturate the coffee grounds or tea.
NOTE:
Specialty always yields
approximately 4 oz. of coffee and
approximately 6 oz. of tea. Green tea
yields approximately 2 oz. of tea.
NOTE:
The unit must remain on for the
Delay Brew function to work.
DO NOT
power off after setting Delay Brew.
NOTE:
If brewing an iced blended drink, fill
the desired vessel with the amount of ice
recommended in the recipe before brewing.
NOTE:
The clock will remain on even if
the unit is turned off. Ensure the unit is
powered on to set Delay Brew.
NOTE:
The brew basket must be securely
closed with either the COFFEE or TEA
filter holder inserted to set Delay Brew.
PREPARING & USING
THE NINJA
HOT & COLD BREW SYSTEM™ – CONT.
3
Press DELAY BREW. DELAY BREW will
illuminate and the clock will begin to flash
“12:00” or the last Delay Brew time that
was set.
4
While the clock is flashing, press the
hour (H) or minute (M) button to set the
time that you would like the Delay Brew
to begin. The AM or PM indicator will
illuminate on the left side of the display
as you are setting the desired time.
5
Once the proper time has been set,
select the size of the vessel that you
would like to brew into.
6
Turn the START/SELECT dial to choose
your brew style. If brewing tea, press
the Tea button to toggle to the
tea menu, and use the bottom dial to
choose your tea type. To change your
brew style while in the tea menu,
press the Tea button again.
7
Once the time, brew size, brew style, and
tea type (if applicable) have been set,
allow DELAY BREW to stop flashing, or
press DELAY BREW to activate. When
activated, the unit will beep and DELAY
BREW and your selected options will
remain illuminated. To cancel, press
DELAY BREW again.
INTEGRATED FROTHER
The Integrated Frother does not heat milk.
1
Add milk to your cup until it is about
1
/
3
full.
- For cold froth, go to Step 2.
- For hot froth, microwave for
45–60 seconds.
2
Pour milk into cup, until it is about
1
/
3
full. (Use more or less milk depending on
your preference.) Microwave for 45 to
60 seconds for hot milk.
3
Swing the arm of the frother toward the
front of the brewer. Install the frother
whisk by twisting it to the right.
4
Hold the cup under the frother and
submerge the whisk just below the
surface of the milk. Press and hold the
button on top of the frother and froth
for 30–45 seconds.
5
Remove the frother whisk by twisting
it to the left. Keep your cup below the
whisk while you carry it to your sink or
dishwasher for easy cleaning.
NOTE:
If you attempt to change your
selections while Delay Brew is set, the
unit will beep and DELAY BREW will
flash. To change your selections, cancel
the Delay Brew.
1-877-646-5288
CP307 P4 BACKLIT UI LAYOUT
2017.12.21
NOTE:
If “CnCL” displays on the control
panel, the brew has been canceled.
Press the START/SELECT dial to begin
the brew again.
