11
Replacing the bobbin
Remove the bobbin
1. Turn the hand wheel toward you
until the needle is in its highest position.
Raise the presser foot lever . Slide the
bobbin cover forward.
2.Take out the bobbin from the bobbin
holder.
Insert the bobbin
1. Hold the bobbin between the thumb
and index finger, and leave about 15cm
of the thread hanging out. Then put the
bobbin into the bobbin holder, pull the
thread, it can be turned anti-clockwise.
2. As shown, pass the thread from right
side to left side through the tension
spring. (Slot A)
3. As shown, pull out the thread from
slot B, make sure that around 15cm of
the thread is hanging out.
4. Replace the bobbin cover plate .
26
16
16
