FLAME
Turn the main power switch on. A long “beep”
sound will be heard when the switch is turned
at ON Position “I”.
Note
: The remote control will lost the memory
for function settings when the switch is turned
at OFF Position “O”.
The flame will be cycled from Flame A – Flame
B – Flame C – Flame Off.
Flame A: full bright flame + little blue
Flame B: full bright flame
Flame C: half bright flame
POWER
SWITCH
NAME
FUNCTION
BUTTON
HEATER
The heater will be cycled from Low – High –
Heater Off. The indicator light on left to Power
Switch (see the
first
picture on last page) will
illuminate when the heater is turned on. The
indicator light will go out within 10s.
Low: (●○)
High: (●●)
Note:
1.Heater can be used without flame.
2.The heater will work when the temperature
set by thermostat is higher than room
temperature.
3.The Fan works about 10s ahead of the
heater, and stops about 10s later than the
heater.
4.The indicator light in the lower fuel bed
(see the l
as
t picture on last page) always
illuminates when heater is on.
HEATER
Turn it to setting 9 first and when the room has
reached a desired level, turn the rotary switch
counterclockwise slowly until the thermostat
just 'clicks' off. The thermostat will then
maintain the room at this selected level. To
increase the temperature, turn the rotary
switch clockwise to a higher setting.
11
