Ninebot Remote Keyfob, Service Manual

Page: 2 / 3

Ninebot PTR
56
Keyfob Battery
Tools Required:
Small Phillips-head screwdriver
Removal
1. Using a small Phillips-head screwdriver, remove the
two fasteners shown in
Figure 66
.
2. Pull the two halves of the keyfob apart.
3. Using a small Phillips-head screwdriver, remove the
two fasteners shown in
Figure 67
.
4. Pull the board out of the keyfob.
5. Remove the battery stack and replace the batteries
(see
Figure 68
).
NOTE
Use three CR2016 batteries. Stack them on top of
each other with the positive (+) sides all facing down
(toward the keyfob buttons).
Installation
1. Install in the reverse order of removal.
Figure 66: Back side of keyfob
Figure 67: Inside of keyfob
Figure 68: Keyfob electronics
Battery Stack