Note:
Please do not move the left-hand stick forward until you hear the
intermittent beep, otherwise the GV 3's motors will start to run.
Do not set the values too low, otherwise you may no longer be
able to control the GV 3.
Speed of the Auto-Return function
It is not essential to set up this function. However, if you do wish
to adjust the Auto-Return function, this is the procedure:
Switch the transmitter on, and ensure that the yaw trim (below the
left-hand stick) is at centre. The throttle stick must be at the Idle
position. Press and hold the right-hand stick, and briefly press
the left-hand stick three times. Now move the yaw trim (below
the throttle stick) to the left to increase the speed at which the
GV 3 carries out the Auto-Return function. The higher the speed,
the faster the red Status LED on the GV 3 flashes. To reduce the
Auto-Return speed, move the yaw trim to the right, and the red
Status LED flashes more slowly accordingly. We recommend a
high setting for outdoor flying, and a low setting for indoors.
Note:
If this mode does not start immediately, repeat the procedure un-
til the Status LED flashes. Please note that the right-hand stick
must not be held pressed in too long, otherwise you will enter
set-up mode for the Dual-Rate values, and set the values to 0.
21
Dual-Rate function
The Dual-Rate function determines the GV 3's response to the
pilot's control inputs. Briefly pressing in the right-hand stick se-
lects one of the two points. The selected Dual Rate is indicated
by the disc at bottom centre of the screen (see "Transmitter stick
mode" on page 8). A solid disc at this point indicates the higher
value; a half-disc indicates the lower value. If you are a beginner,
we recommend the lower value.
Adjusting the Dual-Rate values
It is possible to adjust the two Dual-Rate values individually at the
transmitter. This is accomplished by switching the transmitter on
with the throttle stick at Idle, and moving the right-hand stick down
until the continuous beep switches to an intermittent one. Please
hold the right-hand stick in the stated position the whole time.
When you hear the intermittent beep, you can set a value within
the range 0 to 100 using the left-hand stick. The higher the value,
the more responsive the GV 3 to the pilot's control commands.
The value set always corresponds to the state of the disc on the
screen. This means: if the screen shows a half-disc, you are
adjusting the lower Dual-Rate value (recommended value: 40);
if you see a full disc, then you are adjusting the higher value
(recommended value: 100). Once you have set your preferred
value, release the right-hand stick, and the set value is stored.
Repeat the procedure to adjust the second value.
Operating Instructions - GALAXY VISITOR 3 RTF FTR 2.4 GHz No. NE2529M2
No. NE2529M1
