30
ENGLISH
A
B
Position of
control bar:
Release
Stop
Forward
Operation
Control
The ironer is controlled by the mobile
control
bar
in front of the rollers
(A)
and the
ON/
OFF
switch
(B).
The control bar has three positions,
Release
Stop
Forward
The control bar also provides protection
against touching. The release position light-
ens the roller pressure so that the mangle
cloth can be pulled forward by hand.
Start
Press the
ON/OFF
switch. Lower the control
bar to the
FORWARD
position.
Stop
Raise the
CONTROL BAR
to the
STOP
position. When you are going to resume
mangling again, lower the control bar to
the FORWARD position. The ironer will then
start again.
Release
Raise the
CONTROL BAR
to the
RELEASE
position. Pull out the mangle cloth
For thick ironing
items
If garments are too thick, the ironer will stop
and the red diode beneath the ON/OFF
switch will light up. Release and pull out the
ironing items. Resume ironing with smaller
ironing items.
The mangle cloth may be damp. You
should therefore always leave the ironer
with the ironer cloth fully extended
Motor protection
The mangle is equipped with an
overload
cutout
to protect the electrical parts of the
ironer. A circuit breaker will trip in the event
of overload. If this has happened, the cutout
must be reset by pressing a button on the
right beneath the work table.
Motor cutout
Summary of Contents for 427000937
Page 32: ...Gematech Innovation ...