INSTALLATION
Push Handle Faucet
For easier installation, attach tubing prior to mounting the faucet as described below. Refer to
Figure 3 for the following instructions.
1. Insert polished faucet base (2) and gasket (3)
onto base of faucet (1).
2. Slide white plastic spacer (5) open-end-up onto
the threaded faucet stem.
3. Thread the 3/8" washer (6) and mounting lock nut
(7) onto the threaded stem. Do not tighten until step
6.
4. Thread the quick-connect fitting (8) on to the
faucet stem threads. This connection should be
hand-tightened only. Push one end of blue tubing
forcefully into quick connect side of the fitting (8).
5. Insert tubing and faucet assembly down through
the sink hole.
6. Position the faucet to the desired handle orienta-
tion. From underneath the sink, slip the slotted
washer (4) between the white plastic spacer and the
sink. Securely hand tighten the mounting nut (7).
7. Apply a small amount of FDA-approved silicone-
based lubricant (not provided) to the O-rings located
at the base of the spout. Firmly insert spout assem-
bly into
the top hole of faucet body ensuring it goes
to the bottom of the hold. You may swivel the
faucet left or right.
4
Fig. 3
6
1
2
3
4
5
6
7
8
