Nilox 17NXGCON38001, User Manual

Page: 29 / 57

UPS shutdown

Press the button and hold down for 3 seconds until the device beeps twice. The load will no longer be
powered (inverter off). The device enters standby mode, the fans will continue to run and the batteries will be
charged if the mains are available. If, on the other hand, the mains are not available, the UPS turns fully off
after a few seconds. If the shutdown procedure is run with the UPS in battery mode, after the inverter shuts
down (load no longer powered), the fans will run for a few seconds and then the device will fully shut down.
Self Test

A self test can be run when the UPS is in AC operating mode. Press button and hold down until the device
beeps twice. The UPS will switch to battery mode ( amber color) for about 10 seconds. In the event of
problems, the device will display the error code (LED and will turn on).
Status and alarm buzzer
The following table indicates some of the normal UPS conditions and relevant buzzers.
Status Buzzer
The UPS has an important problem that causes the inverter to
turn off. All functions are disabled.
Long and incessant beep.
The UPS has a problem whose importance does not prevent
load power (via inverter or in ByPass mode).
~ 2 sec. interval intermittent beeps
Battery mode.
~ 1.5 sec. interval short intermittent
beeps
Low battery level.
Succession of very short and fast beeps
(~0.2s).
RS232 port data receipt confirmation. 2 short beeps.
Initial UPS start with automatic test.
2 short and fast beeps repeated at ~2 sec
intervals.
Overload. ~ 3 sec. interval intermittent beeps