Squeegee System 120
Service Manual – SCRUBTEC R466 ... FOCUS II Micro Rider
Squeegee blade check and replacement
Note:
The squeegee must be clean and its blades must be in good condition in order to get a
good drying.
Warning! It is advisable to wear protective gloves when cleaning the squeegee because there
may be sharp debris.
1 Clean the squeegee as shown in the previous
paragraph
2 Check that the edge (E) of the front blade (C)
and the edge (F) of the rear blade (D) lay down
on the same level, along their length; otherwise
adjust their height according to the following
procedure:
◦ Remove the tie rod (G), disengage the fas
-
tener (M) and adjust the rear blade (D); then
engage the fastener and install the tie rod
◦
Loosen the handwheels (I) and adjust the
front blade (C); then tighten the handwheels
3 Check the front blade (C) and rear blade (D) for
integrity, cuts and tears; if necessary replace
them as shown below. Check the front corner (J)
of the rear blade for wear; if necessary, overturn
the blade to replace the worn corner with an
integral one
If the other corners are worn too, replace the
blade according to the following procedure:
◦ Remove the tie rod (G), disengage the fas
-
tener (M) and remove the retaining strip (K),
then replace/overturn the rear blade (D).
◦
Install the blade in the reverse order of re-
moval
◦
Unscrew the handwheels (I) and remove the
retaining strip (L), then replace the front
blade (C)
◦
Install the blade in the reverse order of re-
moval
4
After the blade replacement (or overturning),
adjust the height as shown in the previous step
5 Connect the vacuum hose to the squeegee
6 Install the squeegee and screw down the
handwheels
7
If necessary, adjust the squeegee balance
adjusting handwheel
C
D
I
K
F
J
E
D
C
L
I
M
G
I
P100755