13
english
ATTIX 360-2M
ATTIX 550-2M / ATTIX 560-2MXC
ATTIX 751-2M / ATTIX 761-2MXC
1)
Option depending on model
7. Check the antistatic clamp
(5) for damage and have it
replaced by Nilfisk-Alto Serv-
ice if necessary.
8. Check that the control flap
(6) for filter cleaning works
properly. The control flap
should move back and for-
wards easily.
9. Clean the level hose (7).
10. Fit a new filter element.
11.
Fit the filter holder. Ensure
that it is in the correct posi-
tion.
12. Fit bar and close bar handle.
13.
Dispose of the used filter
element in accordance with
legal regulations.
Never use the vacuum cleaner
without a filter.
1)
Accessory. Order No. shown in section 9.5.
5
7
6
8 Troubleshooting
Fault
Cause
Remedy
‡ Motor does not start
> Fuse of the mains socket has
blown.
•
Connect mains fuse.
> Overload protection switch
has tripped.
•
Switch off the vacuum cleaner
and allow it to cool for approx.
5 minutes. If the cleaner can-
not be started again, contact
the Nilfisk-Alto service depart-
ment.
> Self-acting carbon brush is
worn.
•
Have carbon brushes changed
by Nilfisk-Alto Service.
‡ Motor does not run in auto-
matic mode
> Power tool is defective or not
connected properly.
•
Check that the power tool
works or that the plug is in-
serted correctly.
> The power rating of the elec-
trical tool is too low.
•
Note that minimum power rat-
ing is P>40W
‡ The acoustic warning
sounds. (Reduced suction
power)
> Suction power selected with
suction power control is too
low.
•
Set suction power in accord-
ance with section 4.2.3. „Set-
ting suction power“.
> Hose diameter and switch
position do not correspond.
•
Set correct switch position for
hose diameter.
> Clogged suction hose/nozzle.
•
Clean suction hose/nozzle
> Filter bag is full.
•
See section 7.2.2 „Replacing
filter bag“.