INSTRUCTION FOR USE
ENGLISH
Terra™ 4300B
1464035000(1)2009-06
15
MACHINE OPERATION
WARNING!
Pay careful attention when operating the machine at high speed: sudden steering could cause this three-wheel
machine to become unstable due to weight distribution.
Always reduce the speed before steering.
Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted
1.
marks on the
fl
oor.
To collect light and bulky waste materials, lift the front skirt by pressing the pedal (5); take into consideration that the machine
2.
vacuum capability is reduced when the front skirt is lifted.
CAUTION!
When operating on wet fl oors, it is essential to turn off the vacuum system by pressing the switch (79) to
prevent the dust fi lter from being damaged.
For machine proper operation, the dust
fi
lter must be as clean as possible. To clean it while sweeping, turn on the
fi
lter shaker
3.
by pressing the switch (79) forward for a few seconds.
During this operation the vacuum fan is automatically shut off.
After cleaning the
fi
lter, press the switch (79) backward to restart the vacuum system; then start sweeping again.
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
When the dust fi lter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore.
The hopper (17) should be emptied after each working cycle and whenever it is full (see the procedure in the following
4.
paragraph).
HOPPER DUMPING
Stop the machine by releasing the drive pedal.
1.
Turn the ignition key (72) to “0”.
2.
Engage the parking brake.
3.
Disengage the hook (18) by pulling its lower end.
4.
Remove the hopper (17) by using the handle (19) and by disengaging it from the inner guides.
5.
Discharge all the debris into special containers. To make discharging procedure easier, inside the hopper there are two
different containers (optional) with handle (36).
Install the containers with handle (36), if equipped.
6.
Install the hopper (17) and engage it to the inner guides, then fasten it with the hook (18).
7.
The machine is ready to start sweeping again.
8.
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
Lift the side brooms with the lever (85).
1.
Lift the main broom with the lever (86).
2.
Turn on the
fi
lter shaker with the switch (79).
3.
Empty the hopper (17) (see the procedure in the previous paragraph).
4.
Remove the ignition key (72).
5.
Engage the parking brake.
6.
PUSHING/TOWING THE MACHINE
To push/tow the machine when it is turned off, no special prearrangement is necessary.
MACHINE STORAGE
If the machine is not going to be used for more than 30 days, proceed as follows:
Check that the machine storage area is dry and clean.
1.
Disconnect the battery connector (46).
2.
FIRST PERIOD OF USE
After the
fi
rst period of use (
fi
rst 8 hours) it is necessary to perform the following procedures:
Check the fastening and connecting elements for proper tightening.
–
Check the visible parts for integrity and leakages.
–
https://harrissupplyind.com - To Order Parts Call 608-268-8080
