ENGLISH
INSTRUCTION FOR USE
24
1464035000(1)2009-06
Terra™ 4300B
TROUBLESHOOTING
Problem
Possible cause
Remedy
The machine does not start when turning the
ignition key to “I”.
The battery connector is disconnected.
Connect the battery connector.
The F1 fuse in the box is open.
Replace the fuse.
The battery charger cable is connected to the
electrical mains.
Disconnect the battery charger cable from the
electrical mains.
The machine does not move when pressing
the pedal.
The parking brake is engaged.
Disengage the parking brake.
When starting the machine with the ignition key,
the pedal is pressed, or the operator is not yet
on the driver’s seat.
Start the machine with the ignition key, only after
being on the driver’s seat and without pressing
the pedal.
The FT fuse is open.
Replace the fuse.
The main broom does not work.
The FA fuse is deactivated.
Reset the fuse by pressing the relevant switch.
The side brooms do not operate.
The main broom is not lowered.
Lower the main broom.
The FB fuse is deactivated.
Reset the fuse by pressing the relevant switch.
The machine collects little debris/dust.
The vacuum system is turned off.
Turn on the vacuum system with the switch.
The F4 fuse in the box is open.
Replace the fuse.
The dust
fi
lter is clogged.
Clean the dust
fi
lter by using the
fi
lter shaker or
by disassembling it.
The hopper is full.
Empty the hopper.
The skirts are not properly adjusted or are worn. Adjust/replace the skirts.
The brooms are not properly adjusted.
Adjust the broom height.
The
fi
lter shaker does not operate.
The F2 fuse in the box is open.
Replace the fuse.
The machine operates only when stationary,
otherwise the red warning light turns on.
The batteries are discharged.
Charge the batteries.
If the problem persists, replace the batteries.
The battery autonomy is low.
The batteries are dead.
Replace the batteries.
The battery capacity is low.
Buy batteries with higher capacity (see the
Technical Data paragraph).
The drive system electronic board malfunction
led is
fl
ashing.
The drive system is malfunctioning.
To detect the failure, refer to the Service Manual
(at any Advance Dealer).
For further information contact a Advance Dealer, where it is possible to consult the Service Manual.
SCRAPPING
Have the machine scrapped by a quali
fi
ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
Batteries
–
Polyester dust
fi
lter
–
Main and side brooms
–
Plastic components
–
Electrical and electronic components (*)
–
Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
(*)
https://harrissupplyind.com - To Order Parts Call 608-268-8080
