INSTRUCTIONS FOR USE
ENGLISH
Terra™ 4300B
146 2810 000(2)2008-07
17
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms with harder or softer bristles are available.
This procedure is applicable to all types of brooms.
Check the main broom distance from the
fl
oor as shown
1.
below:
Drive the machine on a level
fl
oor.
•
Keep the machine stationary, lower the main broom
•
and turn it on for a few seconds.
Stop and lift the main broom, then move the machine
•
and switch it off.
Check that the main broom print (A, Fig. 2), along its
•
length, is 0.8 to 1.6 in (2 to 4 cm) wide.
If the print (A) is not within speci
fi
cations, adjust the broom
height as shown in step 2.
Engage the parking brake with the pedal (3) and the lever
2.
(4).
Turn the ignition key (72) to “0”.
3.
Open the hood (7).
4.
Loosen the knob (A, Fig. 3) on the left side of the machine.
5.
Turn the knob (B, Fig. 3) and remind that:
6.
It must be screwed to lift the broom;
•
It must be unscrewed to lower the broom.
•
After the adjustment, hold the knob (B) and tighten the
knob (A).
Perform step 1 again to check the proper adjustment of the
7.
main broom height.
When the broom is too worn to be adjusted, replace it as
8.
shown in the next paragraph.
CAUTION!
If the main broom print is excessive (larger than
1.6 in (4 cm)), the machine regular operation is
affected and the moving or electrical parts can
overheat, thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
S311389
Figure 2
A
B
S311390
Figure 3
Summary of Contents for Terra 4300B 908 4309 010
Page 2: ......
Page 37: ...MODE D EMPLOI FRAN AIS Terra 4300B 146 2810 000 2 2008 07 11 SCHEMA ELECTRIQUE suite S311411...
Page 99: ......
