11
EN
INSTALLATION, USE AND MAINTENANCE MANUAL
2.INSTALLATION
ATTENTION: The entire system must be installed by qualified personnel
in full compliance with standards of workmanship and with applicable
standards and regulations.
2.1 Choice of installation position for main vacuum unit
2.2 Dimensions and technical data chart
Height
Diameter
90
00
0
1000
9
19
210
70
90
00
0
1000
9
19
210
70
108
00
0
1000
9
9
210
70
Model
>>
A minimum
B
C
D
mm
mm
mm
mm
mm
mm
mm
mm
E
C30
T40
A recommended
outlet
inlet
The choice of installation position must be based on these criteria:
• The main vacuum unit must be installed indoor in well ventilated rooms, preferably in a service room
on the lowest floor of the building, like garage and technical service room. External places are allowed,
provided that the vacuum unit is always protected from inclement weather.
• The selected position must have a clear space around the main vacuum unit and well lit so as to make
easy maintenance and repair• Install a 20 V SHUKO power supply socket.
• The wall mounts must allow the installation of the main vacuum unit off the ground at varying heights
depending on the model as shown in the diagram below.
• The main vacuum unit
must not be installed
in rooms where:
- There is a source of heat in the immediate vicinity
- The temperature can reach values lower than ° C and above ° C
- The humidity is very high or flooding may occur
- Flammable or explosive products are stored or handled.
• The installation position must permit the fitting of air expulsion pipes no longer than metres with
pipes diam. 0 mm. After this distance, pipes diam. mm must be used.
C40
