22
-
FORM
NO.
56041803
SR9772
OPERATING INSTRUCTIONS
CHECK DETERGENT TANK LEVEL
DETERGENT CONTROL KNOB
8. Move the scrubber to
fi
lling station by
fi
rst reducing the throttle to low idle following start-up, depress clutch, select range and
gear, slowly release clutch and increase throttle.
CAUTION
When SHIFTING from one range to another, forward to reverse, or reverse to forward, the operator MUST reduce the speed (throttle)
to LOW IDLE, shift range and/or gear, then increase the speed (throttle).
9. To stop and shut down the machine, depress clutch and reduce throttle to low idle, move range and gear levers to neutral, apply
brakes. When fully stopped, apply the parking brake and turn off engine.
10. Open the solution tank access doors on top of each tank.
11. Fill the solution tanks with water. (The solution tanks are linked together, so you can
fi
ll through one access door. Add the
recommended amount of detergent to each solution tank allowing for even chemical dispersion). (Each tank has a capacity of
100 gallons).
12. Fill the recovery tank to 2/3 capacity (150 gallons) with clean water.
13. Fill the detergent tank located directly in front of the right rear wheel with detergent (10 gallon capacity).
14. The high solution light on the scrubber control panel will illuminate when the solution tanks are full.
15. While solution tanks are
fi
lling, inspect the machine. Check and clean out doors, ensure the doors are sealed properly, and
inspect the squeegee blades. Perform maintenance as required.
16. Close the solution tank access doors once the tanks are
fi
lled.
17. Start the scrubber following New Holland operating instructions, release the parking brake and drive the scrubber to work area by
fi
rst reducing the throttle to low idle following start-up, depress clutch, select range and gear, slowly release clutch and increase
throttle.
18. Stop the machine by depressing the clutch and reducing throttle to low idle, move range and gear levers to neutral, apply brakes.
19. Depress clutch and select the appropriate gears to scrub at a speed of 2-3 mph (Low range, second gear is suggested).
20. Activate scrub deck and squeegee switches on the scrubber control panel.
21. Pull the hydraulic control lever back to energize.
22. Begin scrubbing.
23. Adjust the water
fl
ow by turning the solution
fl
ow knob located on control panel to optimize scrubbing performance.
24. Activate the recycle switch on the control panel to start recycling mode. Camel System light will illuminate on the control panel,
when system is operating. The switch is to remain in recycle mode position.
25. To adjust the detergent
fl
ow, turn the camel detergent control knob located on control panel to desired detergent mixture.
https://harrissupplyind.com - To Order Parts Call 608-268-8080