ENGLISH / A-9
FORM NO. 56041749 - SR 2000 -
A-9
OPERATIONS OF CONTROLS AND GAUGES
FIGURE 8a
FIGURE 9
CIRCUIT BREAKERS (See Figures 2 & 8a)
The circuit breakers
(Q)
are located to the left of the steering wheel. When a circuit breaker “pops” out, this is an indication of an electrical problem that must be
corrected before the breaker can be reset.
There can be up to seven circuit breakers in the row. They control the following circuits, beginning with number 1 on the left:
CB-1 = Filter shaker motors
CB-2 = Horn
CB-3 = Starter relay
CB-4 = Ignition
CB-5 = Accessory
CB-6 = Options
CB-7 = Cab Options
GLOW PLUG - DIESEL (See Figure 8a)
WARNING!
It is advised that in no circumstances should either or any other unauthorized starting aids be used at the same time as the Glow Plugs.
To operate the glow plugs, the following procedure should be adopted.
1. Before operating he starter motor, press the “GLOW PLUG” button for approximately 20 to 30 seconds.
2. With the “GLOW PLUG” button still depressed, engage the starter motor until the engine starts.
3. Continue to press the “GLOW PLUG” button for a few seconds after the engine has started until even running has been obtained.
4. If the engine does not start, disengage the starter motor but keep the “GLOW PLUG” button depressed for a further 10 to 15 seconds. When a further
attempt is made to start the engine, keep the glow plugs energized while starting and for a few seconds after the engine has
fi
red until it is running smoothly.
HOPPER LIFT / SIDE BROOM LEVER (See Figure 9)
The Hopper Lift/Side Broom lever
(R)
is located to the left side of the drive compartment. The lever is a three position control that operates the hopper lift, side
broom and optional left side broom.
NOTE
The hopper lift lever will not function until the hopper has been rotated to clear the body of the sweeper.
The lever is spring centered from the rear position. The center position turns OFF the side broom (or brooms) and is the HOLD position when dumping the hopper.
The lever is detonated in the forward position. Move the lever forward to turn ON the side broom when sweeping or to LOWER
(A)
the hopper when dumping the
hopper. Move the lever back to RAISE
(B)
the hopper when dumping. Release the lever when the hopper has reached the desired height. The lever will return to
the center HOLD position.
HOPPER DUMP/RETURN CONTROL LEVER (See Figure 9)
The Hopper Dump/Return lever
(S)
is located to the left of the drive compartment. The lever is a two position control that operates the hopper dump system. The
lever is spring loaded to the center position which “STOPS” rotation of the hopper. To rotate the hopper, move the lever forward to the DUMP
(C)
position and
hold. Release the lever when the hopper reaches the desired position. The return the hopper after dumping, move the lever back to the RETURN
(D)
position.
The hopper will rotate back and the hopper will lower to the seated position. Release the lever once the hopper has been seated in the body of the sweeper.
WARNING!
Never turn off the engine with the hopper in the lifted position.
