Control System
38
Service Manual – Condor
™
EcoFlex
™
, BR 1100/1300 EcoFlex
™
4 Continue to hold the scrub speed and traction control switches until the traction control indicator lights
5 Release the scrub speed and traction control switches The scrub speed indicator will turn off and the
display will show
NEUTRAL/SC-NO FAULT
(speed controller - no fault) The display, switch and indicator
functions in the service test mode are described below
6
To exit the service test mode, turn the key switch off.
Service Test Mode Display
•
Speed Control Status
– This indicator will read
SC–NO FAULT
(speed controller - no fault) if the status signal from the speed
control is normal
– If a speed control fault exists, this indicator will read
SC-FAULT
(speed control fault) Refer to the
Wheel System, Traction
section for details on these codes
•
Speed Control Foot Throttle Status
– The control panel display will read
NEUTRAL
when the operator foot pedal is at rest
– The control panel display will read
FORWARD
when the foot pedal is depressed in the forward direction
to activate its forward drive mode functions
– The control panel display will read
REVERSE
when the operator foot pedal is depressed in the reverse
direction to activate its reverse drive mode functions
Control Panel Switch and Button Functions
•
Scrub System Off Switch
– This switch controls the scrub brush motor(s) Pressing and
releasing this switch will alternately turn the brush motor(s) on and off The scrub off
indicator provides the following status information:
– Off - Brush motor output is off and there is no brush motor current sensed
– Steady Blue - Brush motor output is on and there is normal brush motor current
sensed
•
Scrub ON/Pressure Select Switch
– This switch controls the scrub deck lift actuator as
follows:
–
Pressing the switch the first time will switch on the actuator to lower the scrub
deck. The normal scrub indicator (left blue LED) will light as the actuator is
running. Once the deck reaches the down position, the normal scrub indicator will
blink.
– Pressing the switch a second time will switch off the normal scrub indicator
–
Pressing the switch a third time will switch on the actuator to raise the scrub deck. The normal scrub
indicator will light as the actuator is running. Once the deck reaches the up position, the normal scrub
indicator will blink.
– Pressing the switch a fourth time will switch off the normal scrub indicator
