A-8
- FORM NO. 56041554 - Advenger
™
, Advenger
™
AXP / BR 600S series
A-8 / ENGLISH
INSTALL THE BRUSHES (DISC SYSTEM)
CAUTION
!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1
Make sure the Key Switch
(J)
is off (O).
To access the brushes, remove both side skirt assemblies. Note: The skirts are held in place by a two large
Knobs, loosen these knobs and slide the skirt assemblies off of the Scrub Deck.
2
To mount the brushes (or pad holders) align the lugs on the brush with the holes on the mounting plate and turn to lock in place (turn outside edge of
brush towards front of machine).
INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)
CAUTION
!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1
Make sure the Key Switch
(J)
is off (O)
.
To access the brushes, swing both side skirt assemblies open. Note: The skirts are held in place by a large
cotter pin on each side, remove the pins and swing the skirt assemblies out of the way. Loosen the black knobs (one on each side) on top of the idler
assemblies and remove the idler assemblies. Slide the brush into the housing, lift slightly, push and turn until it seats. Re-install the idler assemblies,
close the skirt assemblies and secure with cotter pins.
