Nilfisk-Advance 56507000, Instructions For Use Manual

Page: 24 / 52

A-24 / ENGLISH
A-24 - FORM NO. 56041656 - Exterra™ / SR 1900
TROUBLESHOOTING
If the possible causes listed below are not the source of trouble, it is a symptom of something more serious. Contact your Nil fi sk-Advance Service
Center immediately for service.
MACHINE WILL NOT START
Possible causes may be:
1 Foot Pedal not in neutral position (ensure pedal is in neutral position)
2 Foot Pedal neutral position is not correctly set (contact your Nil fi sk-Advance service center)
3 Battery is not connected (connect battery)
4 Machine is out of fuel (refuel)
5 Tripped circuit breaker(s) (reset any tripped circuit breakers)
MACHINE WILL NOT MOVE
Possible causes may be:
1 Parking Brake (F) set (release parking brake)
2 Towing Valve in wrong position (set correctly)
3 Tripped circuit breaker(s) (reset any tripped circuit breakers)
MAIN BROOM WILL NOT RUN
Possible causes may be:
1 Debris wrapped around the broom drive (remove debris)
2 Hopper is not completely down (lower hopper completely)
3 Tripped circuit breaker(s) (reset any tripped circuit breakers)
SIDE BROOM WILL NOT RUN
Possible causes may be:
1 Ensure Side Broom OFF switch isn’t selected (push switch to turn ON)
2 Debris wrapped around the broom drive (remove debris)
3 Hopper is not completely down (lower hopper completely)
4 Tripped circuit breaker(s) (reset any tripped circuit breakers)
HOPPER WILL NOT RAISE
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
HOPPER DUMP DOOR WILL NOT OPEN
Possible causes may be:
1 Dump door jammed by debris (remove debris and clean edges of dirt chamber)
2 Tripped circuit breaker(s) (reset any tripped circuit breakers)
SHAKER MOTOR WILL NOT RUN
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
DUST CONTROL SYSTEM (IMPELLER) WILL NOT RUN
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
2 Ensure Dust Control OFF switch isn’t selected (push switch to turn ON)