Nilfisk-Advance 56507000, Instructions For Use Manual

Page: 15 / 52

ENGLISH / A-15
FORM NO. 56041656 - Exterra™ / SR 1900 - A-15
AFTER USE
1 Shake the Hopper Dust Control Filter (LL) and empty the hopper.
2 Check the maintenance schedule and perform all required maintenance before storage.
3 Move the machine to an indoor storage area.
4 Shut down the engine according to the shut down procedures.
5 Make sure the Ignition Switch (TT) is OFF and the Parking Brake (F) is engaged.
NOTE: It is safe to clean this machine with a pressure washer as long as you do not spray directly at or into electrical components. The machine should always
be allowed to dry completely before each use.
TO SHUT DOWN THE DIESEL / GASOLINE ENGINE...
1 Turn all controls to the OFF position.
2 Raise the brooms.
3 Place the Engine Speed Switch (GG) in IDLE and let the engine idle for 25 - 30 seconds.
4 Turn the Ignition Key Switch (TT) OFF and remove the key. NOTE: The 4 cylinder gasoline engine will continue to run for a few seconds after switching the
key to off. This is part of the proper operation of the closed loop electronic control system.
5 Apply the Parking Brake (F) .
TO SHUT DOWN THE PROPANE ENGINE...
1 Turn all controls to the OFF position.
2 Raise the brooms.
3 Turn the service valve on PROPANE Tank (21) OFF.
4 Run the engine until all the PROPANE is dispelled from the line (the engine will stall).
5 Turn the Ignition Key Switch (TT) OFF and remove the key. NOTE: The 4 cylinder LPG engine will continue to run for a few seconds after switching the key
to off. This is part of the proper operation of the closed loop electronic control system.
6 Apply the Parking Brake (F) .
REPORT ANY DEFECT OR MALFUNCTION NOTED DURING OPERATION TO AUTHORIZED SERVICE OR MAINTENANCE PERSONNEL.
MAINTENANCE
Make sure that the machine is kept in top shape by following the maintenance schedule closely. Repairs, when required, should be performed by your Authorized
Nil
fi sk-Advance Service Center, who employs factory trained service personnel and maintains an inventory of Nil fi sk-Advance Original Equipment Replacement
Parts and Accessories.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.
MAINTENANCE SCHEDULE
Maintenance intervals given are for average operating conditions. Machines used in severe operational environments may require service more often.
MAINTENANCE ITEM PERFORM DAILY
Perform the “After Use” maintenance steps X
Check parking brake X
Check engine oil X
*Clean main and side broom(s) X
Check fi lter indicator and lights (hyd & air) X
Check engine coolant level X
Check hydraulic oil level X
MAINTENANCE ITEM 15 hrs. 30 hrs. 150 hrs. 300 hrs. 1000 hrs.
*Rotate main broom X
*Inspect/adjust brooms X
* Check / Clean Hopper Dust Control Filter Using Method “A” X
*Inspect broom housing skirts X
*Inspect hopper seals X
Clean radiator and oil cooler X
Perform engine maintenance X
*Inspect and grease steering spindle X
* Check / Clean Hopper Dust Control Filter Using Method “B” X
* Check / Clean Hopper Dust Control Filter Using Method “C” X
Change the hydraulic “charge” oil fi lter X
Change reservoir hydraulic oil X
Flush the radiator X
Engine fuel fi lter(s) X
*See the Mechanical Repair Service Manual for detailed maintenance information of systems listed. (Sweeping, Hopper, Steering, Dust Control). NOTE: Cleaning
the hopper dust control fi lter is not required on models using the maintenance free bag fi lter.