S
P E A K E R
S
E L E C T I O N
/ V
O L U M E
C
O N T R O L
S
Y S T E M
1
2
6. Using the appropriate volume control on the front of
the SVL-6, adjust the volume of the speakers to the desired
listening level.
7. You can turn off the speakers by turning the appropri-
ate volume control on the SVL-6 fully counter-clockwise
or by pressing the ON/OFF button.
Playing Two or More Speaker Pairs
Simultaneously
1.
Make sure the amplifier or receiver power is OFF and
set the volume to minimum.
2. On the right side of the SVL-6's front panel is a button
labeled PROTECTION. This button activates the SVL-6's
impedance correction circuitry. The circuitry assures that
your receiver or amplifier will see a safe operating load
when playing multiple speaker pairs simultaneously. Since
most receivers and amplifiers are not rated for use below a
4 ohm load, you will need to activate the PROTECTION
button whenever the overall system impedance might fall
below 4 ohms. Use the following chart as a guide for set-
ting the PROTECTION button.
"TECH TIP"
You will need to
activate the SVL-6's
PROTECTION button
whenever the
overall system
impedance might
fall below
4 ohms.
WHEN PLAYING THE FOLLOWING :
1 or 2 pair of 8-ohm speakers
3 or more pairs of 8-ohm speakers
1 pair of 4-ohm speakers
2 or more pairs of 4-ohm speakers
Any combination of 4 and 8 ohm speakers
OFF
ON
OFF
ON
ON
Set the PROTECTION button to the correct position using the chart shown above.
