NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
9
(CONTINUED ON NEXT PAGE)
PROGRAMMING A DEVICE DEPENDENT SEQUENCE
1. Press a source key.
2. Press and hold
SETUP
until the source key LED blinks twice, then release.
3. Press
9 7 8
. The source key LED blinks twice.
4. Press the key to which you wish to assign a sequence.
5. Enter the series of commands (key presses) you want the sequence to execute (up to
15 commands).
6. Press and hold
SETUP
until the source key LED blinks twice, then release.
Now, when you press the sequence key , the remote sends the series of commands you have
entered, but only if the device selected in
step 1
Is active. For example, you could program the
sequence key to turn on both your TV and cable box and select a particular channel, but only if the
TV is selected. If the DVD is selected, this key does not execute the sequence you set up for the TV.
To clear the sequence, repeat
steps 1-6
above, but do not enter a series of commands at
step 5
.
TROUBLESHOOTING
PROBLEM:
1. LED does not blink when you press a key.
SOLUTION:
• Try pressing different keys. Replace the batteries with 2 new AA batteries
PROBLEM:
2. LED blinks when you press a key, but device does not respond.
SOLUTION:
• Make sure the remote is aimed at your device and is not more than 40 feet away
PROBLEM:
3. Source key LED blinks one long blink while in SETUP mode.
SOLUTION:
• An entry error has occurred (for example, wrong key). Try entering the sequence again
PROBLEM:
4. Remote does not control devices or commands are not working properly.
SOLUTION:
• Try all listed codes for the device. Make sure the device operates with an infrared remote
control
