nilco 2638003, Operating Instructions Manual

Page: 39 / 48

15
After use
Please note: When vacuuming extreme fine dust, air per-
meability of the filter will be restricted considerably.
Consquence: low suction power, the filter has to be
cleaned or replaced.
Cleaning of motor protection- and permanent fine dust
filter
Please use warm water (max. 40°C) with a mild soap
solution or a washing-up liquid, etc.
The filter has to be dry before using it again.
Clean the appliance only with a dry or moist cloth. You can
also clean the filter compartment (inside the canister) with a
moist cloth, if required.
Check the accessories, such as the hose, tubes and nozzles,
regularly for blockage and clean; wash out, if necessary, and
let dry.
In the event that the appliance does not perform satisfactorily
(reduced suction power, unusual noises or failure), first
check whether the filters are blocked or dirty or whether there
is blockage in the hose or tubes.
WARNING!
Switch off and unplug the vacuum cleaner be-
fore cleaning. This will prevent the appliance
from accidentally being switched on.
ATTENTION!
Do not use cleaning agents, abrasives or alco-
hol, since they could damage the housing.
en