Nikon AF-S DX Nikkor 18-55mm/F3.5-5.6G VR, Repair Manual

Page: 52 / 113

JAA80351-R.3739.A
- 22-6・F-S DX 8-55/3.5-5.6G VR - dditional Page
Ｍ
サービス
計画課
January���2��8 ���2��8 ��2��8 �2��8 2��8
1.Summery
In order to get necessary data for lens alignment, this board is created for setting a special chart and light viewers
(for chart illumination), upon taking pictures of the special chart with a digital camera.
2.Preparation
Prepare a board (760 x 880 x 20 mm) or 2 cardboard boxes (size 2.��).
Note: Because you have to cut out the shape to embed light viewers, choose cardboard boxes (size 2.��) or
material which can be easily cut. - Ref. Fig.1
3.Procedure (In this document, 2 cardboard boxes are used)
①
As for the 1st flattened cardboard box (size 2.33), check the positions for embedding the light viewers, and cut
out the shape at 5 locations (shaded parts/size 154 x 245 mm) as shown below.
- Ref. Fig.2
Note: Cutting the shape slightly smaller than the actual size of viewers makes it easier to fit the positions of
viewers tightly.
②
Put the 2nd flattened cardboard box (size 2.33) on the above cut-out 1st cardboard together as one, and fix them
by taping at 4 sides. - Ref. Fig.3
③
Then as for the 2nd flattened cardboard box, cut out the shape again by matching the cut-out size of
①
for each
viewer.
- Ref. Fig.4
④
Reinforce the edges of cut-out parts with tape.
Note: To prevent viewers falling off, secure them with tape around the edges. - Ref. Fig.5
⑤
Blacken around the setting board (with black spray, etc).
4.Prevent Viewers from falling off
(In this document, 2-mm width Velcro tape is used.)
s shown above, when viewers are embedded, secure them with square pieces of Velcro tape (hook and loop
fastener) on the back of the cardboard to prevent viewers falling off.
To prevent viewers falling off,
attach Velcro tape on the back of
the cardboard. Inthis document,
2mm-width hook and loop
fastener is used.
88�
5
� 5�� �
38
�
38
�
2
5
2
5
�
5
�
5
��
5
【
Create Setting board of "Lens alignment chart" and "Viewer"
】
INC