Niko Caterpillar HY 60, Operating Instructions Manual

Page: 27 / 35

20
Electric equipment
•
With work on the electric system pinch off the battery in principal (negative pole)
•
Attend to correct connection – at first the plus pole and then the minus pole
•
Attention with battery gases – they are very explosive
•
Avoid spark formation and open flames as well as smoking close to the battery
•
Use only original fuses. With use of too strong fuses the electric system will be
destructed
•
Only activate the starter for a limited time otherwise the winding will get hot
•
Do not make sweat -, bore -, sawing and grinding works at the caterpillar and/or at the
safety framework. Change parts after damage.
Accessory equipment
•
Danger of injury exists when coupling devices to the caterpillar
•
Danger of injury through squeezing exists in the range of the three point linkage
•
Do not step between the caterpillar and the attachments while using the external
operation for the three point linkage
•
Consider the far discharge and the rotor of the equipment with driving along curves
with attached or up-saddled devices in addition
•
Fasten instruments only with prescribed devices
Hydraulical equipment
•
Use suitable aid with the search of leaks because of danger of injury
•
Make absolutely pressure-free before working on the hydraulic system and cultivated
devices lower!
•
Switch off the engine and secure the caterpillar against rolling away (wedging brake/
wedge!) with work at the hydraulic system
•
Attain on the prescribed connections of the hydraulic hose with connecting the
hydraulic cylinders and engines!
•
Bei Vertauschen der Anschlüsse umgekehrte Funktionen (z. B. Heben/Senken) –
Unfallgefahr!
•
The caterpillar is driven, controlled and accelerated with a Joystick (One-hand-lever). If
there are troubles call immediately the service department or the trader.
•
Stop the caterpillar immediately if there are any troubles of the function of the steering
or the brake! Remove the trouble promptly!
•
The suction filters have to be changed by the first after-sales service after 50 working
hours. The hydraulic system is at high pressure