Niko 350-20056, User Manual, Page: 28 / 44

EN 28
350-20056
Attention:
• The walking test is not affected by daylight.
• Reset the DIP switches to their original position if daylight detection is used (application 1 or 2).
3.2.3. Push button
• Short press
A short press (< 1 s) switches the lighting on and off and disables the presence detector for ten seconds. The presence
detector is then automatically reactivated and switches the lighting on according to the selected application.
Pressing the push button briefly with the lighting switched off, will switch the lighting back on. The lighting will remain
switched on while the presence detector detects motion within the detection range and the switch-off delay has not expired.
• Long press
A long press (> 1 s) with the lighting switched on , will switch the lighting off again. The presence detector remains
disabled until it detects motion within the detection range and the switch-off delay + 2 hours has not expired. The
presence detector is then automatically reactivated and switches the lighting on according to the selected application.
Example: The switch-off delay is set to 15 minutes. The presence detector is automatically reactivated 2 hours and 15
minutes after the last motion was detected.
A long press (> 1 s)
with the lighting switched off
, will switch the lighting back on (regardless of the daylight level).
The presence detector remains activated as long as it detects motion within the detection range and the switch-off delay
+ 2 hours has not expired. The lighting is then switched off, the presence detector is automatically reactivated and the
lighting switches on according to the selected application.
If a long press is applied to the push button, the red LED indicator on the presence detector flashes (1 second on, 3
seconds off).
3.2.4. Settings via the IR remote control (fig. 6)
• Lock/unlock
Press this button to unlock the presence detector. The green LED on the presence detector illuminates to indicate the
settings can be changed.
After the settings have been changed, press this button again to lock the presence detector. The green LED goes out.
Note:
The presence detector should be unlocked to change all settings (except Light 1 On/Off ) and re-locked to activate the new
settings. If the presence detector is not locked, it is locked automatically after five minutes. All changed settings will be saved.