Press and hold the power button on the SDM pod for five seconds
until the LED light begins a fast triple-flash. The pod is now in ID
mode, ready to link with the watch. After 10 seconds the pod will
revert to normal operation.
NOTE:
If you are unable to enter SDM LINK OK screen before
the 10 seconds expires, turn the pod off and repeat step 3.
Firmly grasp the HR transmitter with both hands, one on
each end, making sure to touch the sensors on the back side
of the transmitter. There is no ON / OFF switch for the transmitter.
It sends a digital signal during the first 10 seconds of connection
with the sensors.
NOTE:
If you are unable to enter
HRM LINK OK screen before
the 10 seconds expires, wait two minutes
for the HR transmitter to automatically
turn off and try again.
After a few seconds the watch should display SDM LINK OK
and HRM LINK OK. The watch has located the digital ID of the
HR transmitter and will store the ID until you either change
the watch battery or reset the watch.
18
Linking the Digital Components to the Watch
The HR transmitter and SDM pod have unique digital IDs to avoid crosstalk with other components. Before your
components can communicate properly, the watch must be linked to the transmitter and pod to establish and share
this ID. The original transmitter which came with the watch was linked at the factory. Once linked, the digital IDs are
stored by the watch until you change the watch battery or reset the watch. Follow steps through to re-link
the original or any replacement components to the watch.
2
Scroll to RUN
mode
3
4
5
Press and hold all
four side buttons
simultaneously
until the watch
beeps and all
segments of
the watch LCD
flash in the display
SENSORS
