NightWatcher D1 Digital Video Recorder User Manual
39
channel model, the PTZ is link to the related PTZ information on the remote device connected.
Note
：
to link PTZ, need go [Shortcut menu]->[PTZ control] to set preset point, cruise between
points & interval time, etc.
Picture 4.8 PTZ Activation under hybrid mode
【
Delay
】
When alarm is over,recording will last some seconds(10~300sec),then stop.
【
Show message
】
Pop the alarm information dialog box in the local host computer screen.
【
Send EMAIL
】
■ means sending an email to user when the alarm is turned on.
Note:
Set in the [NetService] and send email.
【
FTP upload
】
to tick it, the video & picture of related record channel & snapshot channel will be
uploaded to assigned position.
Note
：
FTP upload need be set at [Netservice]
【
Buzz
】
When alarm happens, device will come out with buzz.
4.3.2 Video Blind
When the video image is influenced by the environment such as bad brightness or reaching the set
sensitivy parameter, the camera mask function is turned on and the linkage function is turned on.
*Same as motion detect function, video blind is different between Hybrid mode & Full digital mode:
Digital channel: not only to enable video blind function at local side, but also to enable the remote device
that was connected. when remote device with video blind, local side will start alarm recording, otherwise
this function is not enable.
Hybrid mode: only need to enable video blind function at local side.
