TM Eco Series
Operating & Safety Instructions
USA – 07/11
Issue 01
27
2)
To disengage the parking brakes, firmly grasp the handbrake lever and pull upwards. Depress
the ratchet release button in the end of the handbrake lever and return the lever to the horizontal
position. Care should be taken when operating the handbrake lever due to the forces involved in
engaging the ratchet mechanism.
4.6.3
CRANEAGE
1)
Observe all of the limitations relating to straps and chains stated above under ‘Transporting’.
(Section 4.6.1).
2)
When utilising the designated lifting points never apply a ‘snatch’ load, i.e. lift slowly to take up
the load before raising. Similarly, do not drop machine when positioning after lifting.
3)
If the machine is to be lifted by crane, use the designated lifting points and observe the
recommendations regarding spreader beams. Individual drawings are available for each machine
type, on request. (See list below.)
D81193
TM34M
D80541
TM34H/T
4.6.4
STORAGE
If being stored for any length of time without use, then the machine should be thoroughly inspected for
the following: -
1)
Grease all bearings /slides, worm drives, etc.
2)
Check batteries for electrolyte levels, state of charge, damage, dirt, etc. Never leave in a state of
discharge for any length of time. If no use of the basket is intended, an occasional “top-up”
charge of the batteries will serve to equalise their charge level.
3)
Leave battery disconnect switch in OFF position to prevent discharge of batteries through
leakage.
4)
If machine is to be left on an incline, chock wheels to prevent creep.
5)
If machine is to be left out-of-doors or in a hostile environment, cover with suitable weatherproof
media to prevent deterioration.
4.6.5
SETTING TO WORK
Before use each day and at the beginning of each shift the machine shall be given a visual and
functional test including, but not limited to, the following
1)
Check all lubrication points for adequate application of grease, oil etc.
2)
Inspect all threads for ease of operation.
3)
Check level and quantity of oil. Remove any contaminants – water, etc.
4)
Check batteries for electrolyte and state of charge.
5)
Check electrics for damage and insulation.
6)
Using base controls, cycle machine over complete envelope in accordance with the Operating
Instructions. Cure any defects.
Summary of Contents for TM34M ECO Series
Page 2: ......