SD Series
Operating & Safety Instructions
USA 03/12
33
4.7.3
CRANEAGE
1)
Observe all of the limitations relating to straps and chains stated above under ‘Transporting’.
(Section 4.7.1)
2)
When utilising the designated lifting points never apply a ‘snatch’ load, i.e. lift slowly to take up
the load before raising. Similarly, do not drop machine when positioning after lifting.
3)
If the machine is to be lifted by crane, use the designated lifting points and observe the
recommendations regarding spreader beams. Individual drawings are available for each machine
type, on request. (See list below.)
D81489
SD34T
4.7.4
STORAGE
If being stored for any length of time without use, then the machine should be thoroughly inspected for
the following:-
1)
Grease all bearings /slides, worm drives, etc.
2)
Check batteries for electrolyte levels, state of charge, damage, dirt, etc. Never leave in a state of
discharge for any length of time. If no use of the Niftylift is intended, an occasional "top-up"
charge of the batteries will serve to equalise their charge level.
3)
Leave battery disconnect switch in OFF position to prevent discharge of batteries through
leakage.
4)
If machine is to be left on an incline, chock wheels to prevent creep.
5)
If machine is to be left outside or in a hostile environment, cover with suitable weatherproof
media to prevent deterioration.
4.7.5
SETTING TO WORK
Before use each day and at the beginning of each shift the machine shall be given a visual and
functional test including, but not limited to, the following
1)
Check all lubrication points for adequate application of grease, oil etc.
2)
Inspect all threads for ease or operation - especially descent valves, brake release valve etc.
3)
Check level and quantity of oil. Remove any contaminants - water, etc.
4)
Check batteries for electrolyte and state of charge.
5)
Check electrics for damage and insulation.
6)
Using base controls, cycle machine over complete envelope in accordance with the Operating
Instructions. Cure any defects.
7)
Ensure that all safety devices and controls operate in accordance with the instructions.
8)
If necessary, perform a load test to establish the machine stability before putting the machine to
work.
