nifty HYBRID DC HR15N Series, Service Manual

Page: 64 / 79

Service Manual
HR15/17N HYBRID DC
English 07/16
58
6.5 Fault Code Display
Code Fault
Description
Action
00 Sounder Error
Open circuit or short circuit of
the base sounder Check wiring to the base
sounder
01 Base Green Button, Bulb Error
Open circuit or short circuit of
the base green button bulb
Check bulb is fitted.
Check wiring to the base green
button bulb
02 Drive Enable Relay Error
Open circuit or short circuit of
the drive enable relay coil Check wiring to the drive
enable relay coil on the PCB
03 Elevated Drive Solenoid Error
Open circuit or short circuit of
the elevated drive solenoid Check wiring to the elevated
drive solenoid
04 Auxiliary Descent Error
Open circuit or short circuit of
the auxiliary descent contactor Check wiring to the auxiliary
descent contactor
05 Machine Enable Relay 1 Error
Open circuit or short circuit of
the machine enable relay1 coil Check wiring to the machine
enable relay1 coil on the PCB
06 Machine Enable Relay 2 Error
Open circuit or short circuit of
the machine enable relay2 coil Check wiring to the machine
enable relay2 coil on the PCB
07 Horn Error
Open circuit or short circuit of
the horn
Check wiring to the horn
08 Base Angle X Channel 1 Error
Error of the corresponding
analogue input during PLC start
up check Check all connections to the tilt
sensor.
- Reset power
09 Base Angle X Channel 2 Error
Error of the corresponding
analogue input during PLC start
up check Check all connections to the tilt
sensor.
- Reset power
10 Base Angle Y Channel 1 Error
Error of the corresponding
analogue input during PLC start
up check Check all connections to the tilt
sensor.
- Reset power
11 Base Angle Y Channel 2 Error
Error of the corresponding
analogue input during PLC start
up check Check all connections to the tilt
sensor.
- Reset power
12 Fuel Sender Error
Error of the corresponding
analogue input during PLC start
up check Check all connections to the fuel
sender.
- Reset power
13 Base Green Button Error
Error of the corresponding
analogue input during PLC start
up check Check wiring from the base
green button.
- Reset power