- 5 -
①
Place the wheel vertically on
the carpet as displayed in the
picture to the right.
②
Remove the rubber caps.
(keep those for future use.)
Caution:
Wheel is not stable
standing vertically.
position of bolts
③
Insert the leg as the drawing illustrates.
Adjust the height evenly on all three legs.
Tighten bolts with allen wrench.
6 different height adjustments .
Height 524mm
Height 554mm
Height 584mm
④
Place the wheel horizontally after
tighting the bolts.
[Attaching]
①
Attach washer and wing bolt to the
side table.
*Do not tighten. Give 5mm play.
②
Slide the side table on to the wheel body.
③
Tighten the wing bolt.
[Removing]
①
Loosen the wing bolt.
②
Slide the side table out.
Bolts
M6 x 12
Height 464mm
・・・
Height 270mm
allen wrench
Connect the power cable to a
230V single phase AC power
outlet only.
May cause fire
by exceeding
outlet capacity.
Do not connect many power
cables to the same outlet.
Make sure the power switch is
off when you plug the power
cable into the AC outlet.
Height 494mm
①
Insert splash pan A into the groove.
②
Insert splash pan B into the groove.
③
Join splash pan A into splash B
Splash pan A
Splash pan B
Wheelhead
Splash pan A
Splash pan B
Leg Installation
Side table Installation
Operation Warning
Splash Pan Installation
Power connection
Step the pedal all the way back
before turning the power switch
off.
Do not operate any switches
with wet hand.
The wheelhead will not move if the
pedal was not all way back at last
power off.
