SI-INTERBUS User Guide
11
Issue Number: 1
Sa
fety
Int
ro
Sup
Mec
El
G
A
Non
Vi
S
Contr
Di
S
F
CM
D tool
Glo
ssa
Two variants are available, 500 kBd and 2 MBd. The specific variant can be identified
from the label located on the top of the option module
2.2.1
Part numbers
The following table shows the available options for the SI-Interbus module.
Table 2-2 SI-Interbus option part numbers
2.3
Date code format
The module date code is a four digit number. The first two digits indicate the year and
the remaining two digits indicate the week of the year in which the option module was
manufactured.
Example:
A date code of 1914 would correspond to week 14 of the year 2019.
2.4
Terminology
2.4.1
Input / Output
Throughout this document, the terms IN (or Input) and OUT (or Output) when referring
to the cyclic data, refer to the data in relation to the Interbus master, so IN (or Input)
would refer to the data transmitted from the SI-Interbus to the Interbus master and OUT
(or Output) would refer to the data transmitted from the Interbus master to the
SI-Interbus module.
2.4.2
Parameter reference
The parameters within the SI-Interbus module use a 2-digit number reference for
the menu number and a 3-digit number reference for the parameter number.
However, some features (such as the cyclic mappings parameters) for compatibility
reasons only support a 2-digit number reference for the parameter, any 2-digit
parameter reference used in this document may also be used as a 3-digit number
reference by adding a leading 0.
So, for example, in
, the setup parameters
15.07
,
16.07
and
17.07
are used, these may be read as
15.007
,
16.007
and
17.007
respectively.
Part Number
Item
82400000021220
SI-Interbus 500 kBd
82400000021230
SI-Interbus 2 MBd
9500-1067
RJ45 to D9F Cable
This date code format (YYWW) is different to the module manufacture date code as
displayed in the module parameter Pr
MM.056
(YYMM).
NOTE
NOTE