OPERATION
After Operation
Operation
Precautions
* Do not operate any switches with wet hands.
* Do not insert hands or body parts into any opening on the pug mill.
* The breakers may shut down by overloading if you forcibly operate the lever. (Operation of
Breaker, refer to P. 8)
* In the event that dry clay remains in the clay hopper, please remove the nozzle and clean the
internal parts. (Disassembly Procedures, refer to P. 7)
*Please do not put a chunk of dry clay or clay refuse into the clay hopper.
* Before placing clay into the hopper clay, please be sure to add water into the clay in order to
put in the condition that you can knead by hands. Otherwise, screw may stop and clay may not
mix well.
1. Switch the power on.
2. Pull the lever up (screw stop). Place clay into the clay hopper in small amounts.
3. Pull the lever down (screws rotate).
4. When the lever is all the way down it can be lifted back up to place more clay in
clay hopper. Continue with this process until you have proceeded all of your clay.
5. Switch the power off when you are finished processing clay.
6. Pull the lever down.
7. Unplug the power cord from the outlet.
1. Pull the lever down and install the hopper cover over the clay hopper.
2. Install the front cover over the end of the pug mill nozzle.
Precautions
*Never operate the pug mill with dry clay remaining in the main body.
*When total cleaning of the pug mill is desired clean internal parts of the main body by following
the disassembly procedures (Disassembly Procedure, refer to P.7).
Please do not leave clay in the main body for a long period if time. Just in case dry clay remains
in Drive housing, do not operate the pug mill in such a condition. Please disassemble the pug mill
and remove the clay (Disassembly Procedures, refer to P.7).
SWITCH
ON (START)
OFF (STOP)
BREAKER
