30
Lamp
Insert the screw part of the holder
and turn it CW
Protective cover set
※
Reflector
4-Mounting screws for protection window
(Tightening torque: 0.45 N-m)
Lamp
※
There is no sheet metal depending
on the manufacturing time.
4.11 Lamp replacement
The life of a xenon lamp is about 1200 hours when it is emitted at 1500 fpm each time. Although rotation speed is displayed, no
flash is emitted. When the flash is intermittently emitted, this indicates the lamp must be replaced. Be sure to replace the lamp with
the following steps. Be sure to use the specified lamp. Please contact us or the retailer where you purchased this product if you
need it.
①
Remove the Rubber cover and the protection window by loosening the 4 screws. Insert a thin screw driver into a hole of
the protection window and pull out.
②
Remove the reflector and Insert the lamp insertion holder as far as it will go. Then turn it CW two or three times and pull
out straight with lamp.
③
Insert new lamp into the lamp insertion holder with seeig the figure below. And press it to the socket in the proper
direction.
④
Turn the lamp insertion holder CCW and pull out. And put carefully the reflector on the case properly.
⑤
The protective cover set is an assembly of acrylic plate, sheet metal, and rubber packing.
Install so that the rubber packing is on the housing side.
* Be sure to use a torque driver to maintain the protective structure.
(Tightening torque: 0.45 N-m)
Insert this part into socket
to fit the groove
Be sure to use a lamp insertion holder.
Pulling out lamp by hand may cause injury.
The lamp is hot and may cause burns.
After emission stops, let the stroboscope sit for 30 minutes or longer.
Be sure stroboscope is cool to the touch before replacing the lamp.
The lamp insertion holder
(One side is threaded)
*Sold Separately
Be sure to turn the power OFF. May result in electric shock
