1201L-1K RTD Controller
User’s Manual
7
Rev.1.1
Attention
Before connecting peripheral equipment the power supply device has to be
switched off.
The connection is effected by means of the included plug-screw terminals.
Clamping range of the plug-screw terminals:
- DC power and network connections (terminals
8
): 2.5 mm
The pin assignment of the connections is described in chapter 3.1, also
containing wiring details.
Voltage
The 12~24 Volt Direct Current connections are through connected in order to
achieve easy wiring.
LonWorks Network
The connection to the LonWorks network is made by means of twisted-pair
cables. The connection “shield” has to be connected to ground in order to
achieve a reliable dissipation of over-voltage on the LON circuits.
Analog Inputs
The actors to be controlled are connected to the RTD Pt1000 inputs. In each
case the connection is effected terminal
1
).
Attention
The 1201L-1K RTD Controller input power supply must within 12~ 24VDC
power supply only.
3.4 Software
Installation
The configuration software of the 1201L-1K RTD Controller has to be
installed by starting the program Setup.exe on the data carrier provided. It
suns under Windows 9x/2000 and NT.
Download url:
http://www.nico-tech.com/download
